DBG$HELP.HLB  —  DEBUG  ACTIVATE  WATCH  Description
    Watchpoints are activated when you set them with the SET WATCH
    command. Use the ACTIVATE WATCH command to activate one or more
    watchpoints that you deactivated with DEACTIVATE WATCH.

    Activating and deactivating watchpoints enables you to run and
    rerun your program with or without watchpoints without having to
    cancel and then reset them.

    By default, the RERUN command saves the current state of all
    static watchpoints (activated or deactivated). The state of
    a particular nonstatic watchpoint might or might not be saved
    depending on the scope of the variable being watched relative to
    the main program unit (where execution restarts).

    To check if a watchpoint is activated, use the SHOW WATCH
    command.

    Related commands:

       CANCEL ALL
       RERUN
       (SET,SHOW,CANCEL,DEACTIVATE) WATCH
Close Help