1    /AVAILABLE

                    Lists all the disks on which there are no units
                    configured.

2    /ENCLOSURE

                    Displays all the disks connected to a particular
                    enclosure.

                    Note: Supported only for SAS controllers.

                    Format:
                             SHOW DISKS/ENCLOSURE = <enclosure_n>

3    /FULL

                    Displays the drive model and the drive serial number
                    in addition to the disk information.

                    Note: For Smart Array P400 series of controllers, the
                          following information is displayed:

                          - Connector Location
                          - Connector
                          - Enclosure
                          - Bay
                          - WWID
                          - Device Type
                          - Disk Capacity
                          - Device Status
                          - Device Vendor ID
                          - Device Product ID
                          - Device Serial Number
                          - Device Firmware Version
                          - Reserved Area (cfg/status information)
                          - Block Size (bytes/sector)
                          - M&P Data Stamped
                          - Last Failure Reason
                          - Physical Disk Flags

4    /MEMBER

                    Displays the disks on which the units are configured.

5    /SPARES

                    Displays the disks that are configured as spare for
                    logical units.

6    /SSD

                    Displays SAS SSD devices and its properties.

7    /VERBOSE

                    Provides logging that can be interpreted by engineering.