VMS Help  —  PEEK  Node Names, Set-up  V-Phase-DECnet-Setup
   The following is a typical DECnet Phase V application setup for
   PEEK and SPY. These commands were generated by the conversion of
   the Phase IV NCP commands listed in the PEEK Node_Names Set-up
   Subtopic: IV-Phase-DECnet-Setup.

    $ RUN SYS$SYSTEM:NCL.EXE
    CREATE NODE 0 SESSION CONTROL APPLICATION PEEK
    SET NODE 0 SESSION CONTROL APPLICATION PEEK NODE SYNONYM TRUE
    SET NODE 0 SESSION CONTROL APPLICATION PEEK INCOMING PROXY TRUE , -
        OUTGOING PROXY TRUE
    SET NODE 0 SESSION CONTROL APPLICATION PEEK IMAGE NAME -
        PEEK$LOCATION:PEEKNET_V7.EXE
    SET NODE 0 SESSION CONTROL APPLICATION PEEK ADDRESSES { NAME = PEEK }
    CREATE NODE 0 SESSION CONTROL APPLICATION SPY
    SET NODE 0 SESSION CONTROL APPLICATION SPY NODE SYNONYM TRUE
    SET NODE 0 SESSION CONTROL APPLICATION SPY INCOMING PROXY TRUE , -
         OUTGOING PROXY TRUE
    SET NODE 0 SESSION CONTROL APPLICATION SPY IMAGE NAME -
         PEEK$LOCATION:SPYNET_V7.EXE
    SET NODE 0 SESSION CONTROL APPLICATION SPY ADDRESSES { NAME = SPY }
    $ EXIT

   These commands are in the file PEEK_SPY_NET$NCP_APPLICATIONS.COM
   which is included with your Peek/Spy distribution.

   You can enable this typical application setup for DECnet Phase V
   by executing this command file. You may also add this to your
   SYSTARTUP_VMS.COM if you always want to have the PEEK/SPY
   applications defined for DECnet Phase V. NET$CONFIGURE.COM may
   also be used to add the PEEK/SPY applications to DECnet.

   See the appropriate VMS Networking manual for more information about
   granting access to PEEK as a network application, and for the
   appropriate commands for doing this, based on the security
   considerations of your site.
Close Help